Thisis the AUDI A4 B8 level sensor 8K0941285P of the headlamp leveling (xenon light), installed on the left front axle. Can be installed in the following vehicles: AUDI A4 B8Positiveto Pin #5. 3. Connect the positive lead of the meter to Pin #4 of the sensor and the negative meter lead to the negative of the power source. Test: 1. As you rotate the sensor arm throughout a full 360 degrees of rotation; the voltage at pin #4 should swing between approx. 0.5 volts and 4.6 volts. Ithought my sensor was toast but I realized it was out of range when i had the car on a jack. Open VCDS go to the Xenon Range - 55 and find the rear angle sensor in one of the measuring blocks. Then see the results and lower or increase the height of the car with a jack. If the numbers change then the sensor is good. 03-25-2019 07:25 PM #5. Coding 00000255 5 Faults Found: 02234 - Right Headlight Power Output Stage (J668) 004 - No Signal/Communication - MIL ON Freeze Frame: Fault Status: 11100100 Fault Priority: 6 Fault Frequency: 32 Reset counter: 170 Mileage: 253210 km Time Indication: 0 Date: 2021.08.12 Time: 19:03:29 Freeze Frame: Voltage: 14.20 V Speed:
Theheadlights still go up and down and still auto level work perfectly fine, all sensors are ok and working amazing, it's a 2010 Audi A4 B8 2.0tdi Avant Sline Special Edition with Xenon Headlights b8 a4 active steering basic setting not performed. deutsch; Mar 14, 2012; Replies 0 Views 4K. Mar 14, 2012.
AudiA4 (2013) – fuse box diagram. Dynamic steering: 5: 2: ESC control module: 5: 3: A/C system pressure sensor, electromechanical parking brake, Homelink, automatic dimming interior rear view mirror, air quality/outside air sensor, ESC button: 5: 4 — — 5: Sound actuator/exhaust sound tuning: 5/15: 6: Headlight range control systern RA2EC.